BB FLOOR SUPPLY

Install tips

Broadcasting flake, the short version

General guidance, not a substitute for your coating system's own instructions.

01

Mix before you cast

Blends ship as separate colors by weight, not pre-mixed. Dump the full box into a clean bucket and mix it dry before broadcasting so the ratio stays even across the floor.

02

Broadcast to rejection

For a full broadcast, keep throwing flake into the wet basecoat until it stops absorbing and chips sit on the surface. That's rejection — it tells you the coat is saturated.

03

Work in sections

Don't try to broadcast a whole garage in one pass. Work in manageable sections so you're casting into wet coating the whole time, not racing a skin that's starting to set.

04

Let it cure before foot traffic

Cure time depends on the basecoat/topcoat system, not the flake itself — follow your coating manufacturer’s schedule, not a rule of thumb.

05

Scrape before topcoat

Once the broadcast coat is hard enough to walk on, scrape and vacuum loose chips before rolling topcoat. Skipping this leaves a gritty, uneven finish.